TELESCOPE OPERATIONS

This procedure provides guidance for correcting problems associated with the DCR . This page should be referred to directly as instructions may change frequently. For software related problems not described below, contact the Software Division. For hardware related problems, contact the Digital Group. See current callout lists for individuals responsible. Unless the observing situation/observing friend suggests otherwise, the callout person should be contacted. Refer to the current callout policy as needed.

The character ^ is used to emphasize spaces between dialog elements.

New DCR problems should be entered into this list by operators to mark the need for new actions. For diagnostic purposes, it's important that these actions be followed and fully recorded in OpsLog.

These terms are used to describes what procedures should be followed given specific DCR problems. They should also be used when describing problem/failure entries in OpsLog and when consulting callout personnel.

• restart: Use CLEO TaskMaster. Click on the tab for algol and select the DCR process. Press the Stop button and then the Run Once button. Note: It may be necessary to do a complete system stop/start if restarting the DCR process doesn't correct the problem. Either action requires reconfiguration of the DCR.

-- DavidRose - 6 Feb 2008